GenVibe - Community for Pontiac Vibe Enthusiasts

cc333

I was fortunate enough to find 03/04 consoles with the plug and harness as well as the double lid in local junkyards to replace the consoles in both my 05 and 08 Vibes. The double lid is padded and way more comfortable than the single. Junk yard or used parts site are probably your best bet. Very g...

cc333

I don't think you'd need a new wheel, from that ebay listing it looks like it fits through the airbag cover, which is something I try to avoid messing with. You might consider just getting a decal to put over it, such as https://www.grafxwerks.com/pontiac/vibe-2003-2004/steering-wheel-arrowhead-ove...

cc333

Don't know your year, but both my 2003 and 2005 Matrix's had the extra 12v plug in the center console. Is it not just the same 12v plug/harness that's in the dash? I would think it would be listed as a 12v accessory power outlet or something along those lines. If both 12v+/- wires are there, would ...

cc333

in https://forums.genvibe.com/phpBB3/viewtopic.php?p=160235#p160235 Josh wrote Called Toyota yesterday...With a little digging they found this P/N82166-01010-Wire $16.26 This is SUPPOSED to be the harness from the chassis wiring harness to the 12vdc socket. Here are the P/N and prices for the socke...

cc333

I was working on cleaning out years of dirt and crud from under(and inside) the center console when I remembered that provisions exist for a second cigarette lighter-style plug in the storage bin under the arm rest, which would be very nice to have. However, I can't figure out what it's called, so I...

cc333

I realize I'm responding to an old thread, but I have a similar problem. The interior of my '06 (bought new 6/2/2006 with 26 miles on the odometer :) ) is stock, save for the odd part here and there I've had to replace over the years, but the steering wheel emblem is original, and as such, all the p...

cc333

I know this is an ancient thread, but does anyone have any photos of the procedure without the Photo Bucket watermark? I'm planning on replacing the headlights, and I find the existing photos somewhat hard to make out.

c

cc333

Hmm, that's too bad.

I guess the Vibe and Matrix are more different than they seem.

c

cc333

I know this thread is a bit old, but I thought I'd offer something that might help clear up the mystery of the Vibe's blank third button. I was browsing for Vibe parts on eBay, and I came across this listing for a Matrix bezel (the one with the clock), but notice the buttons: s-l1600.jpg The third b...

cc333

I installed a radio that looks very much like the Vibe's, except it has a cassette player (I had wanted one in there since we bought it new in 2006). It works 100% fine and looks exactly like the Vibe's stock unit, except it has the cassette player I'd always wanted :) I don't know what car it came ...

cc333

I'm back from a long hiatus!

Our '06 Base has reached 203k miles and still going (mostly*) strong.

*Something happened with the accelerator today that made it almost un driveable until I reset the ECU. Hope it's nothing major!

c

cc333

Hi, I'm looking for a few replacement buttons for the radio in our '06 base Vibe, and was wondering if anyone here had some. Specifically, I'd like the AM/FM, #4 preset, EQ, and CD Eject buttons. Also, if anyone has a stock radio that they'd be willing to part with for cheap (particularly if it has ...

cc333

Any chance you have hinges and door stopper for the front passenger side door?

The door got pinned against a post while backing up several years ago, and it hasn't been quite right since.

c

cc333

Hello Everyone, It's been awhile since I was here last, but we did get the tensioner replaced by a nearby mechanic who actually figured it out (after I told him what I thought it was, and why), and it sounds like new again! The unnecessary replacement A/C compressor works about the same as the old o...

cc333

Yes, and we've already put around 3,000 miles on our new car! Anyway, P0741 is popping up like mad now, and I'm interested in some opinions. OK, so, since becoming aware of what exactly the code is describing, I've familiarized myself with what the car feels like when the LTC engages (slight drop in...

cc333

Yeah, we probably haven't changed it as often as we should've, but doing it from now on couldn't hurt, could it? 23,000 miles per year is kind of hard (I hadn't realized!) Well, as long as it still drives OK, we're going to keep using it. In case I haven't already, I must note that this code was pop...

cc333

Very nice write up! Anyway, one minor correction: we bought our 2006 base Vibe, and it came standard with the AC plug (offset on the right, with the on/off switch for it in the center). And the part of the passenger side door panel which carries the cloth-like stuff is separating from the rest of th...

cc333

New wheels time. We already got some. This is only a secondary/hobby car now. Drive-ability is unaffected at this point, so I think I'll ignore it until something more obvious goes wrong. Thanks! c p.s. There is this strange tendency for it to get stuck in third gear (it happened twice yesterday, b...

cc333

OK, the light came on today after about 500 miles. Not bad!

Trouble is, after I reset it, it came on again after only 13.6 miles.

Oh, well. It's a common, but not very fatal problem it seems.

c

cc333

Hi,

It's about 97 outside, yet the Outside Temp display is saying it's 67?

Is there some sensor I can check?

Why would this happen?

EDIT: It seems to have fixed itself....

c

cc333

OK, I think the doors for the side compartments in the back cargo area are rattling a bit, so I'll start there. After that, the paneling on the rear hatch is pretty bad looking, and because the clips have loosened and the plastic has stretched and deformed slightly with age, this is likely a major c...

cc333

Hi,

I was wondering how I might reduce some of the rattling noises some of the plastic panels are making now that they're more than 8 years old.

It's not a big deal, but if I can do something quick and cheap, I'd like to give it a try.

c

cc333

Ah, OK. I didn't realize that.

I guess I'll look around for the whole assembly, then.

Thanks for the suggestion,

c

cc333

Hi, In my continuing project of fixing up our Vibe, I'm now looking for a fog light lens. Many years ago (when the car was still relatively young), I think a bird hit the right hand fog light lens, which was apparently made of glass, and smashed it out. It has worked fine in this condition, but I'd ...

cc333

I'm sorry to hear that! i think that's more a important matter to tend to, so don't worry about being late!

Anyway, good to hear that about the buttons. Now that our Vibe runs almost like new, I want it to look like new as well, inside and out

It's slow going, but I'll get there!

c

cc333

Well, the cost was justified, and the tensioner has been replaced (we had a mechanic do it instead, as I wasn't sure if I could do it myself). It sounds good as new now, so the rattle is gone! Yay!! He also found that the transmission fluid was low (!) and that it *might* contribute to the slight sl...

cc333

OK. By the way, what is the condition of the front panel? Mine's all ugly, as I mentioned. A few imperfections are OK, though (our current radio is pretty bad, so almost anything would be better). If you wouldn't mind posting a picture or two of each radio when you get a chance, that would be great ...

cc333

I might be interested in the one with XM.

Thanks,

c

cc333

Thanks, NascarXprt, but I think I already have one in the works.

However, if it has a cassette deck, I might be interested

Also, how much $$$ were you thinking?

Thanks,

c

cc333

I discovered how to remove the drive belt, but I don't have to, as it's obvious the tensioner is bad at this point (at slightly over 1,000 ROM, it actually "wobbles" and it squeaks violent.y; definitely time for a new one). Now all I have to do is justify the cost.... Nothing terribly new ...

cc333

Aah, this might explain the noise on our '06 Vibe. I guess a replacement is in order. It lasted about 190,000 miles, so that's not bad. I don't understand why all the mechanics we consulted missed it, though, if it's such a simple fix (simple in the sense that it doesn't require any major work beyon...

cc333

I was thinking of that, but I need to figure out how first. I've done it before on a '92 Ford Explorer and '98 Ford Windstar, and have a special tool for the job, so it can't be too difficult. I'll try this and report back with my findings. A question or two in the meantime: is it possible for a fai...

cc333

I'm actually going to just buy a new radio from someone on here (whose name I don't remember offhand).

I will keep the current one, however, as I can still spruce it up with a nice new face and button set at some point.

Thanks!

c

cc333

For some reason, I wasn't notified of this reply....

We do have an auto salvage yard nearby, actually.

If I get up the nerve to put up with their attitude, I'll go take a look.

Thanks for the tip!

c

p.s. I managed to fix the OD button, so that just leaves me with finding the indicator panel.

cc333

Does any of this affect any of the 2003-2008 Vibes?

I haven't heard anything about it, so I'm not sure....

c

cc333

Nothing? OK, well, I decided to look at the rattle again, and it's beginning to sound more like a binding pulley somewhere, because it's clearly coming from the front of the engine where the belt runs. At a little over 1,000 RPM with the A/C engaged, it makes a terrible noise that sounds less like a...

cc333

Hi, Since the rattle doesn't seem to be affecting anything, I'll leave it alone for now, as I don't think it's related to the P0741 trouble code, which is the main reason for my posting here. Anyway, I did some research on this issue, and it turns out that this code coming up at random on an otherwi...

cc333

Are you sure you stated the code correctly? Shouldn't it be P0741? Oh, yes! P0741! Sorry.... Maybe your catalytic converter is falling apart inside. I am just guessing. Do you think so? Would that explain the exhaust smell? I'm assuming you had the PCM checked/changed from the recall? Yes, we had t...

cc333

Hi All, This is my first "real" post here (I've posted a couple times in the buy/sell sub forum)! When I found this site, I was really intrigued, as I never thought there would be an enthusiast forum for this car! Anyway, we have one (hence my reason for joining), a 2006 2WD base model, bo...

cc333

I'd be interested in your radio! How much to ship it to either 94549 or 95451? I'm in California, near San Francisco. The one in our '06 Vibe (factory original) works okay, but the front panel looks very worn and ugly, and it would be nice to refresh it. Also, any chance you salvaged the floor shift...

cc333

What does this device do? Will it work on a base model 2006 Vibe with standard engine?

I'm not certain what 2ZZ-GE means, so please excuse my ignorance here.

c

cc333

Anybody?

c

cc333

OK, thanks for the tip! The buttons are not the victims of nail polish remover, I'm afraid. Just heavy-ish usage. It's OK, and most of them still work fine, so I'll just take my time here to figure it out. I redid the LCD backlight, so I guess I'll just redo some of the buttons as well. It's a very ...

cc333

Hi, Also on my wishlist are these two items: The little plastic plate thing that has the gears printed on it (I'm not sure what it's called). The overdrive button for the gearshift knob (and associated wiring, if possible). I'm looking to spend as little as possible, as I'm on a tight budget. Thank ...

cc333

Hello, I'm new here! first Post!! Anyway, any chance you have the stock radio? We have an '06 Vibe, bought new, and its interior has a ton of wear and tear (nothing serious, just annoying), and the radio seems to have taken the brunt of it (many of the button faces are worn off, the tuning knob is e...

Search found 45 matches