GenVibe - Community for Pontiac Vibe Enthusiasts

Namron

I have all my components in a single fairly contained cabinet. So I bought a generic 8" fan and hung it behind the components. It's plugged into the switched outlet on the back of the receiver. Now when the components are on the fan is blowing air accross them.

Namron

Watch for the '03-'04 charcoal vibe, about 15 seconds after the police car gets split in 1/2.As far as the movie goes, I thought it was pretty good.

Namron

Since the vents are used for keeping the attic cooler and therefore helping the shingles last longer. In the last two two houses I've owned I've added a thermosticly controlled fan in the vent on the end of the house. You need to have plenty of vents to the attic or you'll create a vacuum.Having the...

Namron

Hey, CP I can't answer what to do personally, but I'd head down these two paths:Talk to the service manager about starting the process of getting it replaced through MajorGuard. If he sees it as bad as your describing I'm sure he could help in getting is replaced.Secondly, I would take it to a compa...

Namron

Well I call redline, and got an answer.The reason why the Mobile1 did not work and why Dave (at RedLine) would not recommend the Redline 75W90 NS is because of a Friction Modifier additive.He would however recommend 1 qt of the MT-90 and 1.2 (or so) of MTL. This is because the GM part # is actuall c...

Namron

Opps I ment 75W90 NS (cut-n-paste error), So does that make my question any different?

Namron

Hi Dave,I've been doing some reading the the redline products, and further reading on the forum. Why are you recommending MT-90 over the 75W140NS? The 75W140NS is GL-5 rated and the MT-90 is GL-4. Maybe 75W140NS was not available when you made your decision?See http://www.redlineoil.com/prod...ID=18...

Namron

I just got off the phone with Valvoline and they suggested pumping the clutch a couple of time when this happens. If double pumping fixes the problem then it might be a problem with the clutch fluid. I'm not holding out much hope in this.I plan on trying their method end of this week when it gets co...

Namron

Hi DavidPIL,Thanks for the information. At first driving, (when it was warm) I was VERY happy with the shifting, it seemed to slip in to gear 2X as good as before. But when it got cold, down in the teens on Thanksgiving, I noticed I had a problem shifting into 1 and 2. I thought this was due to the ...

Namron

Well, also here in Ohio, I got to try out my new Goodyear TripleTreds on my GT. I'm happy too.

Namron

Bottom View Transaxle Drain Bolt

Attached files

Namron

Bottom View filling Transaxle

Attached files

Namron

Top View filling Transaxle - CloseUp

Attached files

Namron

Top View filling Transaxle

Attached files

Namron

DIY 2003 GT Transaxle Drain-N-FillIâ€™m not a mechanic, havenâ€™t played one on TV or ever stayed at a Holiday Inn Express. So use this information at your own risk.After reading the service manual (no reference to my 6 speed transaxle???), owners manual, and reading on the forum I decided to tackle...

Namron

I'm in.

Namron

Do you also watch Invasion? I think both shows are okay, but it's bad that they came out at the same time, and both have "Glowing" creatures in the water. Just a little too confusing in my opinion...Namron

Namron

I think the only major part after that was the police chasing boy to the ocean where he released "Nihm" into the ocean.Or did that part happen before. Namron

Namron

Quote, originally posted by MarkM04 Â»Pulling the plug only removes about half of the fluid, but it's better then not changine it at all. If you change it more frequenlty, you will keep a good supply of fresh atf in it. I think if you changed it every 30k miles, you'd be doing great.Since you just d...

Namron

Sorry to hear about your new car.Quote, originally posted by ragingfish Â»Yeah, it took me a while, but I think this one is Erica. The whole "E" thing is coincidental. I just went through a bunch of names in my head until one felt right...Go with the spelling "Erika" it's the Ger...

Namron

$24 as the GB price??? That's the regular price for the Hyper White when you go to the website. Sorry, I guess I'm missing something here?

Namron

My first name backwards.Namron

Namron

CP, I seem to remember seeing a Product at Auto Zone that might help. I was on a display out in front on the Parts Counter, with other AC charging supplies. It was some sort of Oder Away product geard towards AC. This was during the summer, and those displays I'm sure are gone now. But, I wonder if ...

Namron

POLO, I could be interested, depending on the GB price, I been watching for that actual information.Also, I noticed this on their Forum:Email go@streetunit.com with your forum ID and recieve a $5 coupon to be used on anything at StreetUnit.com.see:http://www.thestreetforum.com/forum/Namron

Namron

Excellant Idea, on how to remove the bulb! Very creative indeed.

Namron

Last summer I found myself in a simular situation, older truck was damaged, cosmetic only, I only wanted the $. I was asked to get 3 estimates and submit them. Boy was I supprised how much these estimates could be. I submitted the 3 highest estimates and told them I wanted it fixed at the "high...

Namron

I believe I'm using the Regular Version. I vagily remember but I think it was the Akron 66.Hope this helps.

Namron

eilros,I'm using flexable mount to hold my myfi. I've got it attached to the passenger front left seat/floor bolt. It shoots forward then I bend it up to position the myfi in the space between the shifter and passanger seat front left corner. Orginally I had it come straight up from the seat/floor b...

Namron

Lee, I've done this with my '03 Single CD player. I used wires 1 & 3 going from the CD player to the "main Radio". Yes, you need to have CD in the Player for the Aux input to work.Namron

Namron

You could cut out a big piece of cardboard and park over it. Then take the cardboard to the dealership if your not sure what is leaking. Hopefully they will be able to tell you. Namron

Namron

ok I think I found the Engine Coolant Drain on my '03 GT, after an hour of looking. It's on the Firewall side of the engine 1/2 up. I opened it a little and had what I believe is my Coolant come out. Since the Vibe is new to me I double checked the radiator and the coolant is red. You'll need to use...

Namron

see: http://www.genvibe.com/images/...e.pdfThe 1500lbs is the weight that can be towed. Page 4.34 says there is a sticker in the Glove compartment with the car. I just ran out to my car for my '03 GT the Vehicle Capacity Weight is 860lbsNamron

Namron

You own a Vibe... You've got to be alright. I'll get a money order tomorrow morning and get it sent out.

Namron

As long as your Matrix bumper protector on is is new condition, no scratches and adhesive still on the back, I'd like to buy it.Namron

Namron

McVibe, I have a MiFI and initially used the fm modulator. I found that for my traveling back and forth to work it was ok. I had found a frequency that seemed to be clear over that distance. But, when going further into the "big city" I would start getting some station bleeding through. So...

Namron

Very Nice! It's got me thinking...I noticed the care you took not to "overspray" the writting "Max AC" next to the AC button.

Namron

I did some searching and this is what I came up with. But I've never seen it at local stores. Has anyone else?http://www.sjzaino.com/Zaino/Z16.html

Namron

I plan to be there.Shoot it's only 20 minutes from my house Namron

Namron

Hey the_nite_owlYour right with a jack that has enough connections it should work.Aa far as where to place the switch... I put mine on the side of the radio behind the trim. Then once a year when I want to use the cd player it just tilt the trim up and flip the switch.Namron

Namron

I just saw these on ebay. Not custom but might work for you.http://cgi.ebay.com/ebaymotors...wItem

Namron

The main reason to to use the switch/relay is allow a way to select back to the built in CD player. By only using the jack you will "lose" that ability.Namron

Namron

If I'm following what your saying, here's what I think you need to do. Completely around the Red and the white wire is "shielding" wire. This is the Ground wire. What I did, and think you need to do is attach these two grounds to the Radio case.If you follow this try it (and I understood y...

Namron

Can you post some pictures?Maybe a little on how you did it?

Namron

What year is your Vibe? From what I've read/tried those type of Aux devices won't work on the '03. The radio internally won't support it.The device (GM12-AUX version2) I had tried was also from PIE and I even called in advance to make sure it would work. They told me it would. But in the end it did ...

Namron

binary,I did end up getting an "Empty" cd created and use it. But your right any cd would work.Additionaly, if you go the DIY route, I epoxied the switch to the left outside of the radio case. I don't imagine using the cd player much now and lifting the access cover to the radio is too eas...

Namron

binary,I rewired my '03 Single CD just this past weekend with a Relay. Other than the tight confined space it was pretty simple.From picture I found referenced here to the Matrix web site I cut the left and right channel audio lines going from the CD player to the internal radio AMP. You need a DPDT...

Namron

I was wondering... Instead on adding a relay or a switch. Why not create an "Empty CD", since one has to be spinning anyway and then just "tap"/solder directly into the left and right channel as indicated. This would possibly allow fewer changes to the Radio.I've tried burning an...

Search found 47 matches