intakes & warranties

1.8-liter VVTL-i (2ZZ-GE) and VVT-i (1ZZ-FE) engine, transmission, exhaust, intake, and performance tuning discussions
Post Reply
cieglo
Posts: 214
Joined: Tue Jan 11, 2005 10:13 am

intakes & warranties

Post by cieglo »

I'm a new Vibe owner, 1 week as of yesterday, and I love my GT. It's a 2003 and is great fun to drive. But enough is never enough. I'mm looking at K&N, Injen and Bomz intake systems. Does installing one these have any factory warranty implications?
Vibe GT '03, Lava Red 2-tone, 16" wheels, Moon'n'Tunes, Injen CAI, ACT clutch, vented rotors, Tein coil- overs, Grafxwerks decals, lead foot on the gas and white-knuckled fist on the stick & Hankook RS-3 for AutoX http://noraracing.net/
PhillyVibeGT
Posts: 453
Joined: Fri Oct 15, 2004 12:12 am

Re: intakes & warranties (cieglo)

Post by PhillyVibeGT »

No, there are no warranty implications, there is a federal act that allows aftermarket bolt-on products without voiding the warranty. If you go to injen's website they have it posted. Good Luck! Enjoy your GT.
04 GT Satellite Monotone17'' Fittipaldi Fins on Falkin Azenis ST115'sMoon and Tunes/Sirius Satallite RadioInjen CAI/Magnaflow Cat-back Exhaust GM Top Spoiler/Debaged SilverStar Fogs "I wasn’t born rich, I’m good looking instead"
Mr. Poopypants
Posts: 3428
Joined: Mon Nov 18, 2002 11:59 pm

Re: intakes & warranties (cieglo)

Post by Mr. Poopypants »

Congrats!! and Welcome to GenVibe. I wish I had lift
A bartender is just a pharmacist with a limited inventory.
nismo
Posts: 2068
Joined: Tue Dec 02, 2003 11:01 pm

Re: intakes & warranties (cieglo)

Post by nismo »

Welcome to the forums . Well, depends on how much of your warranty is left. I mean, if you're really concerned about your warranty being voided, I would just recommend getting a K&N filter for now just to be on the safe side. And when your warranty is up, get whatever performance parts you want. But if you don't have much warranty left anyways, I would just recommend getting the Injen. It's not going to hurt your car in any way. So, I would say go for it.
2008 Chevy Cobalt SS Turbo - Fun stuff under there somewhere 1998 Nissan Sentra - Sold2004 Pontiac Vibe - 107k and SoldCosmo CAI
Raven
Posts: 2922
Joined: Tue Sep 30, 2003 10:58 am
Location: Lac Ste. Marie, Quebec

Re: intakes & warranties (TRD4reel)

Post by Raven »

Put on a CAI and if you need warranty work done and your worried about it, put the airbox back on before you bring it in. It only takes about an hour. You'll feel and hear the power gain.
nismo
Posts: 2068
Joined: Tue Dec 02, 2003 11:01 pm

Re: intakes & warranties (Sunny)

Post by nismo »

Quote, originally posted by Sunny »Put on a CAI and if you need warranty work done and your worried about it, put the airbox back on before you bring it in. It only takes about an hour. You'll feel and hear the power gain.I agree
2008 Chevy Cobalt SS Turbo - Fun stuff under there somewhere 1998 Nissan Sentra - Sold2004 Pontiac Vibe - 107k and SoldCosmo CAI
cieglo
Posts: 214
Joined: Tue Jan 11, 2005 10:13 am

Re: intakes & warranties (Sunny)

Post by cieglo »

Thanks for the info!
Vibe GT '03, Lava Red 2-tone, 16" wheels, Moon'n'Tunes, Injen CAI, ACT clutch, vented rotors, Tein coil- overs, Grafxwerks decals, lead foot on the gas and white-knuckled fist on the stick & Hankook RS-3 for AutoX http://noraracing.net/
Mavrik
Posts: 8072
Joined: Sat Jan 03, 2004 6:41 am

Re: intakes & warranties (Sunny)

Post by Mavrik »

Quote, originally posted by Sunny »Put on a CAI and if you need warranty work done and your worried about it, put the airbox back on before you bring it in. It only takes about an hour. You'll feel and hear the power gain.Thats what I did when my MAF went south after the first install of my Injen CAI haha.
2007 stage 2 Satin White Pearl Subaru STi 2008 stage 2 Subaru STi hatch See my car at: Mavrik's car page
kostby
Posts: 2422
Joined: Thu Jan 22, 2004 2:52 pm

Post by kostby »

Welcome to the Encyclopedia of Vibe!Yeah, it seems that the Mass Air Flow thingie goes south shortly after a lot of CAI installs. Mere coincidence or evil plot by GM/Toyota?
Image

My 2003 Vibe Base Auto 2-tone Salsa "SalsaWagon" was built in May 2002. I acquired it in Feb 2004/Traded it in on a 2016 Honda HR-V in Feb 2018.
Mavrik
Posts: 8072
Joined: Sat Jan 03, 2004 6:41 am

Re: (kostby)

Post by Mavrik »

I think it has to do with a volt spike in the system maybe... Next time I'll keep it disconnected when I install the battery, then hook it up afterwards. Its just really weird...
2007 stage 2 Satin White Pearl Subaru STi 2008 stage 2 Subaru STi hatch See my car at: Mavrik's car page
knoxville2013
Posts: 39
Joined: Mon Sep 27, 2004 11:46 am

Post by knoxville2013 »

after i put on the cosmo intake, if i dont let the car warm up for about 5-10 minutes then it will never rev past 4500. but after a few minutes it will go the full 6200 or however far it goes. im not sure if it has to do with the MAF sensor..but does this happen to anyone else?
nismo
Posts: 2068
Joined: Tue Dec 02, 2003 11:01 pm

Re: (knoxville2013)

Post by nismo »

That rev limiter kickc in so you don't melt the motor together. We have an aluminum block, so if it heats up too fast then the motor can melt together. That rev limiter has been there even before you do any mods to it. So, yeah, that's perfectly normal.Inder
2008 Chevy Cobalt SS Turbo - Fun stuff under there somewhere 1998 Nissan Sentra - Sold2004 Pontiac Vibe - 107k and SoldCosmo CAI
Lucky317
Posts: 69
Joined: Wed Jan 12, 2005 4:28 pm

Post by Lucky317 »

must be a vibe thing cause the celicas don't have a problem with the maf. we have found that it gets dirty and can cause some minor issues over time. but al you have to do is remove it, spray a lil cleaner and it's back to new.
Controlled Inertiathe first 3 N/A 8 second 1/8 mile celicas 2000 Celica GT-S 6spd - All motor 185whp 136 wtqBest 60' - 1.959 best 1/4 - 13.7 @ 101 mph Best trap - 102.78 mphBest 1/8 - 8.853 @ 81 mphFor my various install/repair pictures or car vids go here: http://www.everythingcelica.com/vip/lucky
knoxville2013
Posts: 39
Joined: Mon Sep 27, 2004 11:46 am

Post by knoxville2013 »

ok thanks, that makes sense...i guess i have just been noticing the revs more now cause of how much louder it is. thanks though
wicked1981
Posts: 1552
Joined: Fri Oct 31, 2003 6:15 am

Re: intakes & warranties (cieglo)

Post by wicked1981 »

Congrats and welcome to the forum.
2006 Pontiac G6 GTP3.9L V-6 240hp and 241 lb-ft or torque18" Aluminum, five-spoke, flangeless200 Watt, 8 speaker Monsoon sysChrome dual exhaust tipsLiquid Silver MetallicBorla Custom ExhaustDr. Speed Cold Air Intake
cieglo
Posts: 214
Joined: Tue Jan 11, 2005 10:13 am

Re: intakes & warranties (wicked1981)

Post by cieglo »

Thanks. Everyone posts a lot of good info and ahven't come across any bad apples yet...this is a nice place to visit.
Vibe GT '03, Lava Red 2-tone, 16" wheels, Moon'n'Tunes, Injen CAI, ACT clutch, vented rotors, Tein coil- overs, Grafxwerks decals, lead foot on the gas and white-knuckled fist on the stick & Hankook RS-3 for AutoX http://noraracing.net/
goodvibe
Posts: 915
Joined: Sun Jul 27, 2003 10:39 pm

Re: intakes & warranties (cieglo)

Post by goodvibe »

The often MAFs go south because they get a light coating of oil from the filters. Don't over oil and let them sit out for a day before installation. If it happens, pull the MAF and spray it clean with some carb cleaner. You probably don't need the dealer. It happened to me with a new drop in and it cleaned right up. It never happened again but I decided to sell the filter after a few thousand miles. If you get a CAI, you'll have less power below 3k or a bit higher on the GT and gain alot at the top.
Vibe GT, TRD springs, Progress bar, STB, Unichip, Borbet E 16x7.5, 225/50 Bridgestone RE750, beefed up grounds and battery bypass capacitors(had em laying around)
MoonDogg
Posts: 363
Joined: Mon Jun 28, 2004 11:50 pm

Re: intakes & warranties (cieglo)

Post by MoonDogg »

Welcome and good pick on the GT... gotta love the lift... good luck with the intake and I am sure you will get all your questions answered here...
2004 Vibe GT Fusion OrangeOptions: M&T, Monotone Paint, 35% TintMods: Kenwood Excelon KDC-X659 HU, Orion CS200.4 amp, Kicker Comp VR 10" sub, Megan Racing STB, Injen CAI, Magnaflow Cat-Back, brass shifter bushing, underbody orange neon's.
ragingfish
Posts: 11022
Joined: Tue Oct 15, 2002 8:23 am

Re: intakes & warranties (PhillyVibeGT)

Post by ragingfish »

Quote, originally posted by PhillyVibeGT »No, there are no warranty implications, there is a federal act that allows aftermarket bolt-on products without voiding the warranty. If you go to injen's website they have it posted. Good Luck! Enjoy your GT.Not ENTIRELY true.They can't void your warranty just for having installed the intake.But if somehow, they can prove, damage was caused as a result of that add-on product, then yes, they can deny you warranty coverage.For example. Let's say there was a hole in your intake filter you weren't aware of. Somehow, a small pebble gets into that, and goes into your engine, and "blows it up." You, my friend, are SOL, because that product was (A) not GM approved and (B) was at fault when that stone got sucked in.However, if, let's say, your power window motor stops working. They can't tell you your warranty is null and void just because of the intake. The problem has to be proven to be a direct result of that modification.
YES!I still visit GenVibe periodically. I have not forgotten about my "original" family over here!

2009 PONTIAC G8
3.6L V6 (256 HP @ 6300 rpm, 248 ft-lbs. @ 2100 rpm)
Post Reply