OK, so I'm going a little overboard now that I'm stuck indoors and my imagination is getting the best of me. This could be good OR bad. Anyways, while repairing my bro-in-laws 2007 Honda Rigeline drivers side seat, I studied and admired the electric grid which heats up the lumbar section of the seat (see attached pic). You can view the entire repair process at my cardomain site.
http://www.cardomain.com/ride/...age-7 This was an SOB to repair but the end results came out quite nice! Knowing now how all this goes together & work, it wouldn't be all that difficult for me to install a similar setup into the Vibe two front seats. This would be a late summer/fall 2011 project if I were to indulge in it. Also, now that I can get to my Pfaff 545 industrial sewing machine (hasn't been used in about three years) I'm getting the itch to do more sewing again So basically I'm wondering if anybody took on a challenge as this OR know of others that have. If so forward me the link/thread so I can further explore if I want to do this or not. Thanks ............ Tim