Installing OEM utility bars

~MRVIBE2006~ · Post by **~MRVIBE2006~** » Thu Feb 28, 2008 12:29 am

I just purchased a set of the OEM utility bars and had a question: How does one install these? I can see that the racks go in the channel there between the OEM racks but I don't know how to get the end caps off to slide them in. Any suggestions? FYI: I got them at a dealership as these particular bars weren't available on any websites that I could find.

Kamikaze · Post by **Kamikaze** » Thu Feb 28, 2008 12:33 am

You have to pry the caps off, I believe there are 2 clips that hold them on, you just have to be careful when prying on them that you don't break anything... I think there's a write up somewhere here on how to do it.

Kamikaze · Post by **Kamikaze** » Thu Feb 28, 2008 12:41 am

I think this is it:http://forums.genvibe.com/zerothread?id=11484

Installing OEM utility bars

Installing OEM utility bars

Re: Installing OEM utility bars (~MRVIBE2006~)

Re: Installing OEM utility bars (Kamikaze)