Rainczech - 2010 Vibe Base 1.8L

Park your vehicle in a thread here - list your vehicle info, pics, etc. all in one place.
Post Reply
Rainczech
Posts: 9
Joined: Sun Nov 27, 2022 10:25 am
Location: State College, Pennsylvania

Rainczech - 2010 Vibe Base 1.8L

Post by Rainczech »

Just thought I would set up a post for my Vibe!

The Meat:

Vicky "Vehicular Manslaughter" the Vibe
- 2010 Pontiac Vibe Base (1.8L) in Navy Blue Metallic
- Purchased in 2022
- Odometer: 137,000

The Potatoes (Things I've Done to Her):
- 2023:
Aftermarket Stereo (Jensen w/ Touchscreen & Bluetooth)
New Speakers (All but the rear right were shot upon purchase)
Replaced Starter
Brakes
Regular Maintenance

- 2024:
Blizzak Snow Tires
Replaced an Ignition Coil

- 2025:
Alternator
Brakes
Regular Maintenance

- 2026:
Water Pump
Front Shocks
New Tires (Have an upcoming move cross country and found lots of things to fix / upgrade)
Installed 1 1/4-In Tow Hitch Receiver, and Matrix Roof Rails / Rack

Old Pic:
Image
🚙 - Vicky "Vehicular Manslaughter" the Vibe: 2010 Base 1.8L
vibedrivermatt
Posts: 599
Joined: Fri Jan 25, 2008 8:44 am

Re: Rainczech - 2010 Vibe Base 1.8L

Post by vibedrivermatt »

Awesome. Thanks for sharing it. Yours still appears to be in great shape cosmetically if it still resembles the old pic. :D

Mine has a 1 1/4" tow reciever hooked up as well. I mainly use mine to hold a mountain bike rack and sometimes haul my harbor freight 4x8 light trailer.
Rainczech
Posts: 9
Joined: Sun Nov 27, 2022 10:25 am
Location: State College, Pennsylvania

Re: Rainczech - 2010 Vibe Base 1.8L

Post by Rainczech »

vibedrivermatt wrote: Sun May 31, 2026 5:53 pm Awesome. Thanks for sharing it. Yours still appears to be in great shape cosmetically if it still resembles the old pic. :D

Mine has a 1 1/4" tow reciever hooked up as well. I mainly use mine to hold a mountain bike rack and sometimes haul my harbor freight 4x8 light trailer.
Still looks good! Only cosmetics i've been worrying about addressing is rock chipping on the hood.
I need to get a bike rack! Used a small hitch carrier for a cross-country move, had to tap into the license plate light wiring to run to a new plate mount on the carrier since original plate location was blocked. Hoping I can get a bike mount that doesn't obscure the low plate on the Gen 2.

Image

Image
🚙 - Vicky "Vehicular Manslaughter" the Vibe: 2010 Base 1.8L
Post Reply