Metallic rattle noise

1.8-liter VVTL-i (2ZZ-GE) and VVT-i (1ZZ-FE) engine, transmission, exhaust, intake, and performance tuning discussions
Post Reply
User avatar
Kelpie
Posts: 27
Joined: Fri Nov 23, 2007 11:49 am

Metallic rattle noise

Post by Kelpie »

Hey All,

We have a hollow metallic rattle type of noise when the car is in gear and the brake is on. When we accelerate, the noise goes away. I think this may be a motor mount. Anyone have an idea of what it is?
Salsa Guy
Posts: 1775
Joined: Thu Oct 07, 2010 10:46 pm
Location: Greater Tulsa Area

Re: Metallic rattle noise

Post by Salsa Guy »

You may want to check the Heat shield on the exhaust manifold. To check the mounts have someone in the car with it in drive break on and give it some gas and watch the motor. If it moves more than an inch then it's time to check motor mounts.
05 Matrix XR 4WD and 03 Vibe GT
"If you want Government to solve your problems, then you are the problem!" BMSR
Trix MODS: SRI w/ AEM filter, Vibrant/Magnaflow Cat-back, Alutec Lightweight Crank Pulley
GT MODS: Cosmo SRI, DRL, Auto Stop
Raven
Posts: 2922
Joined: Tue Sep 30, 2003 10:58 am
Location: Lac Ste. Marie, Quebec

Re: Metallic rattle noise

Post by Raven »

+1 on exhaust heat shields.
User avatar
Kelpie
Posts: 27
Joined: Fri Nov 23, 2007 11:49 am

Re: Metallic rattle noise

Post by Kelpie »

Well, I checked the heat shield and it is solid. The motor mounts move about an inch and that's all. I'm wondering if the transmission could be making that noise, but it will go away when the engine is in neutral and also when you accelerate to anything over a couple miles an hour. The noise is more like a dense sounding rattle, nothing that a heat shield would make. It's similar to the noise I got once when I had tons of ice around the exhaust pipe when I was driving in deep snow and it was rattling against the body.
Platinum76
Posts: 26
Joined: Wed Mar 25, 2009 6:50 am

Re: Metallic rattle noise

Post by Platinum76 »

the exhaust donut gaskets are an issue... mine does the same but its more a "chirping" sound. Had the one after the manifold replaced... now doing it again... fft.
Post Reply