Wanted: need a few parts for 03 vibe GT

[DraziWDragon]

Pm if you have these for sale.

Rear cargo area RUBBER fitted weather mat.
Manual shifter leather boot without holes.
Shift knob with leather still intact.
Driver side fender in "frost white" color.
OEM seats other than the 2003's only option, gray color.
Valve springs for a 2zzge motor.
Any OEM ground fx panels. Or OEM replicas will do.

Most importantly.....
An engine hoist hook that sits on the back, driver side corner of the 1.8l vibe/trix engines.

Please & thank you.

[A Psycho Martyr]

On the seats man, you can always do what I did.

Pull em out and spray the sides w/ black vinyl/fabric dye.

Duplicolor sells it. No need to pull teh covers off, just remove the seats and tape off the middle section.

Spray the rest black and you have stock looking 2 tone seats. Mine came out great

[Bad Vibe]

I have a complete 2zz gt head x/ valve springs and hook

[DraziWDragon]

I have a complete 2zz gt head x/ valve springs and hook

i repied to the pm before reading the post.
shipping might be a bit high for my need.

I have the master engine rebuild kit, but the kits dont ever come with valve parts, so i had to napa the valves,
and need springs as a backup, just in case mine are effed.

UNLESS, someone has a 2zzge engine for the ponyota, that runs well, but has high miles for a cheap price.
This way, i can just slap it in my car so i can drive it, while i rebuild mine original.

I even bought the official GM service manual for the GT. books weight about 20 pounds, and are fatter than an xbox.

Ive been without my car since june. I WANT MY BABY, BACK ON THE ROAD!!!!!!

Did you know, even the GM service manual says you need to use another tool, as the other lift hook?

@Bad Vibe
Where in ny you located? maybe ill have a friend drive me there instead of shipping stuff. I may just buy a bit more parts if I see in person.

[DraziWDragon]

On the seats man, you can always do what I did.

Pull em out and spray the sides w/ black vinyl/fabric dye.

Duplicolor sells it. No need to pull teh covers off, just remove the seats and tape off the middle section.

Spray the rest black and you have stock looking 2 tone seats. Mine came out great

Sounds like a good idea, but it's the lighter gray that I hate, and those are what's stained. So I'll probable make the black, and keep the dark gray sides, original.

I've taken the seat covers off before, sprayed degreaser, stain remover, purple power, and after all thos didn't work, just threw it into the washing machine with detergent. Let it line dry, and to my surprise (not really), the stains were untouched and still there.

So my advice to anyone that has little kids, is....
Don't let there kids juice boxes spill on your seat. If it dries, your are screwed.
I think in my case, it was pedialite