09 Vibe lost cup inserts, and floormats

[MannyL]

I lost the inserts that go in the center console to hold cups. If someone can tell me the dimensions of them I could fabricate some out of foam.
Also the driver's side floor-mat is ragtag on the upper left side. I want to replace it with one that will attach to the hooks. Any suggestions?

Thanks in advance

[vibenvy]

Check car-part.com. I'm sure you could easily find a junkyard near you with a 2009+ Matrix or 2009-2010 Vibe to grab the cup holder inserts from for cheap.

As far as the floor mat goes, I recommend getting some rubber ones. They hold up much better than the carpeted ones and are much easier to clean.

[MannyL]

Check car-part.com. I'm sure you could easily find a junkyard near you with a 2009+ Matrix or 2009-2010 Vibe to grab the cup holder inserts from for cheap.

As far as the floor mat goes, I recommend getting some rubber ones. They hold up much better than the carpeted ones and are much easier to clean.

Do they make rubber ones with the holes for the clips?

[ponta2147]

Check car-part.com. I'm sure you could easily find a junkyard near you with a 2009+ Matrix or 2009-2010 Vibe to grab the cup holder inserts from for cheap.

As far as the floor mat goes, I recommend getting some rubber ones. They hold up much better than the carpeted ones and are much easier to clean.

Do they make rubber ones with the holes for the clips?

I know the WeatherTech ones do. I assume the factory rubber ones would as well.

[vibenvy]

Do they make rubber ones with the holes for the clips?

Yes. I have the GM Accessories Premium All Weather Floor Mats and they do have the holes for the clips on the driver's side. I also believe the Husky Liners floor liners and floor mats have them as well, in addition to the WeatherTech ones that ponta2147 mentioned.

[MannyL]

I'm still looking for the cup holder no luck so far. As for floor mats I got some carpeted ones that didn't have the holes and a coworker put them in and added grommets.

[trb]

I'm still looking for the cup holder no luck so far. As for floor mats I got some carpeted ones that didn't have the holes and a coworker put them in and added grommets.

I have a set of the dividers I pulled from a 2010 at a salvage yard close by me. The other person I offered them to has not been back on here for over a month, so if you want them, send me your address via PM.

[MannyL]

I'm still looking for the cup holder no luck so far. As for floor mats I got some carpeted ones that didn't have the holes and a coworker put them in and added grommets.

I have a set of the dividers I pulled from a 2010 at a salvage yard close by me. The other person I offered them to has not been back on here for over a month, so if you want them, send me your address via PM.

Parts arrived and fit perfect now my coffee won't spill any more. Just need to resolve my audio issue now.