Low End Torque after Magnaflow Cat-back installed

SilverExpress · Post by **SilverExpress** » Thu May 19, 2005 7:21 am

Has anyone felt a decrease in low end torque after installing the magnaflow catback? Do you find yourself giving it more gas to keep up with stop and go traffic?

nismo · Post by **nismo** » Thu May 19, 2005 7:45 am

Well Jose, I wish I brought the Vibe to the meet. I could have shown how it sounded and everything. But I didn't have access to it at the time. And to answer your question, there seems to be some torque there, but I can't really tell until I drive it without the exhaust when I take it off to put it on Shagginwagin's.Inder

Mase · Post by **Mase** » Thu May 19, 2005 7:45 am

I actually felt a significant torque increase. The pedal just felt more responsive. I have a 2zz engine though. I guess it may affect your 1zz differently.You may want to reset your ECU and try again.

nismo · Post by **nismo** » Thu May 19, 2005 7:59 am

He doesn't have it yet. But Silver, I would recommend running this setup on your car. JP/Trial Header, JP midpipe, and a Borla exhaust. That would definitely set your car off nicely.Inder

scherry2 · Post by **scherry2** » Thu May 19, 2005 10:11 am

I have an Ingen CAI and a full Magnaflow catback. I have no problems and mines a base vibe.

Low End Torque after Magnaflow Cat-back installed

Low End Torque after Magnaflow Cat-back installed

Re: Low End Torque after Magnaflow Cat-back installed (SilverExpress)

Re: Low End Torque after Magnaflow Cat-back installed (SilverExpress)

Re: Low End Torque after Magnaflow Cat-back installed (Mase)

Re: Low End Torque after Magnaflow Cat-back installed (SilverExpress)