AEM v2 cai?

MadBill · Post by **MadBill** » Fri Jul 18, 2003 8:59 pm

Anyone seen this advanced design yet? Looks promising, but no listing yet for Vibe/Matrix. Do we need a write-in campaign?http://www.jcwhitney.com/product.jhtml? ... 4133SC0703

ragingfish · Post by **ragingfish** » Sat Jul 19, 2003 11:11 am

I'm quite content with my Injen.

dmitri · Post by **dmitri** » Sun Jul 20, 2003 8:43 am

yea i looked at the AEM i would get the 2 if it was available....but its not so whatever im not getting a different CAI. But if you dont have one yet, check it out email them or whatever, aem makes good stuff.

MadBill · Post by **MadBill** » Sun Jul 20, 2003 11:34 am

I think I will drop them a line, dmitri. I have seen equations for approximating an inlet tube to a 4 cylinder plenum, and for the base vibe they seem to suggest a tube about the stock diameter and only ~ 17" to 19" long*, which would be a "short ram HAI" unless I ran it through the hood! Maybe the double diameter of the AEM 2 compensates, allowing the longer pipe to reach cold air... *The article suggests using a "slide trombone"-like setup to adjust the length on the dyno to get it exactly right. When (if!) I ever get on a chassis dyno, it would be easy to do with the hood open, and if the length was short and critical, I'm sure I could come up with a way to bring cold air to the filter location.

dmitri · Post by **dmitri** » Mon Jul 21, 2003 2:28 am

AEM v2 cai?

AEM v2 cai?

Re: AEM v2 cai? (MadBill)

Re: AEM v2 cai? (silverawd26)

Re: AEM v2 cai? (dmitri)

Re: AEM v2 cai? (MadBill)