Accessory Switch Blank Removal?

[Vibetastic]

HelloAnyone know how to pop out the rectangular blank that fits on the left side of the dash next to the coin holder? I'd like to put a switch there.

[ColonelPanic]

The easiest way is to just grab the coin holder and pull it straight back to remove it, then reach in from there and pop out one of the blanks.

[kevera]

That's the easy part.The hard part is cutting the blank to hold a switch.

[scherry2]

LOL your so right. order a few extras.

[Vibetastic]

Hey! It worked. While sitting in traffic this morning, I pulled out the change holder and was able to remove the blank. Thanks!I've considered installing a small push switch for another horn I want to install. I'm not sure how to get the wiring from the switch to the engine compartment without drilling a hole.

[Vibr8tr]

There arn'y many ways. I think most go through where the wiring harness goes in. No matter what you are going to have to cut somewhere, the vibe is sealed up pretty tight.