Service Manual Page Request

Body kits, spoilers, lights, and anything on the exterior of the vehicle
Post Reply
McVibe
Posts: 245
Joined: Sat Apr 02, 2005 12:23 pm

Service Manual Page Request

Post by McVibe »

Okay so I'm installing some sidemarkers on my Vibe today and I could really use the Service Manual page (if it exists) on how to remove the front quarter panels on the Vibe. I would be eternally greatful to the GenVibe Gods The Panel I need removed (With Photoshopped Side Marker Location)

Attached files
2004 Vibe Base Cosmo Racing CAI (Orange) Eurolite Xenon Headlights, foglights, reverse light, Licence Plate Lights and Dome Lights:star: JVC KD-DV5100 Headunit 7" Sharp LCD 2 12" Legacy 500w Subwoofers 400w Legacy Amp Custom Bult Sub box 3 Pillar pod Gauges Painted Engine Cover Jom Billet Aluminum Stubby Anntena
nygiantzz1
Posts: 701
Joined: Mon May 15, 2006 8:32 am

Re: Service Manual Page Request (McVibe)

Post by nygiantzz1 »

I don't have the service manual, but I don't think you need to remove the panel. The location you noted for the side marker can be accessed by removing the wheel well liner. Once you jack up the car, remove the wheel and the liner, you will have all the room you need to install the side markers and run the wire. You will probably break a few of the retaining clips that hold the liner in place. You can get new ones cheap at almost any parts store.
McVibe
Posts: 245
Joined: Sat Apr 02, 2005 12:23 pm

Re: Service Manual Page Request (nygiantzz1)

Post by McVibe »

Yea I came to this conclusion earlier. I was going to install today at my friend's garage, but got too distracted with the Wii Hopefully I'll get this installed before this weekend is over though.
2004 Vibe Base Cosmo Racing CAI (Orange) Eurolite Xenon Headlights, foglights, reverse light, Licence Plate Lights and Dome Lights:star: JVC KD-DV5100 Headunit 7" Sharp LCD 2 12" Legacy 500w Subwoofers 400w Legacy Amp Custom Bult Sub box 3 Pillar pod Gauges Painted Engine Cover Jom Billet Aluminum Stubby Anntena
Post Reply