Can i wire a bazooka Powered sub directly off of the current sub???

[Markt2717]

hey good question i think, can i wire from the existing factory sub, to the high output input on the Bazooka Sub? does anyone know if the sub has MORE thank 2 wires? (like a bose, or a normal monsoon wire? oh yea PS:) i just installed REMOTE CONTROL underbody led's. i dont know why more people dont do this. but it is very annoying to do so. the wiring is just difficult. it would be one thing if it were just straight neons, but this was patterned led's which has like 23123213123 different patterns (30)

[binary]

good question.The sub is a dual coil (4 wires)... not sure if the Bazooka can handled two channels on the high input - but that should work fine.

[Markt2717]

couldnt i go off just 2 of those?

[binary]

I couldn't honestly tell you. I'd hate to give you advice that fries your M&T's amp in the process.I don't see why you couldn't just not power the sub at all and only use one of the channels to drive the bazooka.