Got bunch of fault codes on OBD:

P0138
O2 sensor circuit high voltage (bank 1, sensor 2)

P0453
Evaporiate emission control system pressure
Sensor/switch high input

P0606
ECM/PCM processor fault

P2111
Throttle actual control system - stuck open

I suspect that the car went to a "limp mode" due to a "low level of gas", however tank is half full.

I cleaned most of the connectors from corrosion and then I started the car today, it only runs up to 2000 rpm and the fuel gauge shows that the tank is empty... did I break something?

And on the rear end water touched seats bench. Any connectors to look there? A fuel pump is there.

The box under the drivers sears is an airbag module, right? Will replace it.

And the inverter, not sure if I have seen it that under the seat, what is the exact location? Will need to replace this one too.

For now will focus on cleaning all the connectors from corrosion.

virologist, appreciate your advices!

Now, the range sensor, is it accessible from under the car? Does anyone have a good manual for replacing that part?
Thanks.

The only option I have is to fix the car myself and it only has 90k miles.. making it a history isn't an option. I am willing to dedicate my own time and money for parts. And the water didn't touch the dashboard, as I said it touch ECU on a right side just below the glove box, obviously no water in ...

Hi ALL! My 2005 Vibe got flooded recently. On a passenger side water got just above engine computer and on the left side (which was slightly higher) it touched the ODB port but didn't touch a fuse box. The engine is fine but I am having electrical problems.. First the car couldn't start and I replac...