GenVibe - Community for Pontiac Vibe Enthusiasts

I installed a new Pioneer HU. WIred the preouts to my factory 200W amp (Moons and tunes). WHen I change sources or stations I get a sharp thump through the speakers. Does anyone know the cause and better yet, a solution?One hint--I use an old RCA speaker cable to splice into the harness fromthe preouts. WOuld I be better off building my own from speaker wire and RCA plugs? WHat gauge, if so?Should I have just wired in the HU speaker output, instead of pre-out?ANy help is appreciated.

i had this problem too i fixed it by using the regular speaker outs on the hu and feeding it through one of these http://www.scosche.com/scosche/electronic/OEA4.asp it worked like a charm and did the jobhere is an old thread [URL]http://forums.genvibe.com/zerothread?id=4968[/URL]