Page 1 of 1
Tach Feed ECU Pinout
Posted: Wed Oct 18, 2006 12:00 pm
by FlynHwian
Just wondering which wire on the ECU is for the ECU readout.I just recently purchased a shift lamp and it runs best if you give a direct feed from the ECU and it didn't come with any wiring schematics. Now ive seen the ECU readout pdf file but im still confused, has anybody else put an aftermarket shift lamp on their Vibe GT (2zzge)?
Posted: Tue Oct 24, 2006 12:31 pm
by Celtic_Curse
Search for this topic. I know its on here I used it to instal my shift light too.
Re: (Celtic_Curse)
Posted: Tue Oct 24, 2006 9:08 pm
by joatmon
Quote, originally posted by Celtic_Curse »Search for this topic. I know its on here I used it to instal my shift light too.
http://forums.genvibe.com/zerothread?id ... 77searched titles for shift light
Re: (joatmon)
Posted: Thu Oct 26, 2006 5:53 am
by satur9
i was searching for shifltlight info as well. on autometers web site it says pin 27 black wire is the tach feed on the instrument cluster harness for tach. save you from running all the way over to the ecu.
Posted: Sat Oct 28, 2006 4:03 am
by Celtic_Curse
Thats where I wired mine into.