Ok guys sorry the delay had to wait to get the OBD2 scanner. So I plugged the scanner in and did the test and there is no communication with the ecu, I tried both with the key off and turned to start position. So my ECU is bad I assume, but would that cause the fuse to blow??

Ok I have set up an account same user ghornsby

oh yeah i am posting these off my phone most of the time so i wont get the pop ups. I am later today going to look at the wires to see if there is a break somewhere that could be causing the issue. i will start with the injectors.

It is blowing when I am in the start position. I haven't seen your PM's but I will check my inbox.

I am still working out the issue. I decided to check the AM2 again and it was blown. When I replaced it I tried to start it again and nothing so I checked the fuse again and it had blown again. So that tells me then there is a bad wire some where. Any suggestions? I tested all the grown wires for co...

Yeah checked all the fuses, except for the fusible link. Any ideas where this would be? i have searched everywhere. Could it be inside the plastic wrapping around the wires? it just seems awfully thin for that.

I checked everything except the ECU anyone have a diagram where the ECU would be? I know its behind the glove box but need a little more guidance.

I hope i have posted in the right area. I have a 2005 Vibe 2wheel 1.8L. My girlfriend tried to jump it when it died at the gas station and when she did the jumper cables were put on backwards. Of course with this it blew almost every engine fuse with the 100 amp Alt-s. The care will not start, i hav...