I have a 2006 Base non-power, I ordered the button on eBay and was hoping this would be a simple plug and play scenario. I got the switch today and removed the panel above the switch bank. So far the most helpful thread I have found on here has been this one: viewtopic.php?t=44525
So here’s my issue: when I removed the panel there is an open wiring harness, but it doesn’t match up with the switch that I have. Does anyone know (1.) if all Vibes were wired for the rear hatch release? (2.) what is the open harness in the photo from my car for?
Thanks in advance.