GenVibe - Community for Pontiac Vibe Enthusiasts

Hey guys.
So I've have had not posted since the fall on my SC vibe project; Winter put it on hold.

but it will be ready this spring. I'm just doing the little things I think I can do like install the new EMS (already installed new header) and a little later installing XRS or GTS fuel injectors.

The goal for today is just to get the Greddy e-manage ultimate to my stock engine settings so once the SC is installed then it'll get a proper tune.
both lights on the unit are steady so far as I'm concerned I'm good to go

Can anybody help me to get all #'s for the Parameter settings on the emange program?
I Would greatly appreciate it!

I wish I knew, but the best bet if probably to contact the guys at MonkeyWrenchRacing, as they can send you a base tune to get you started.

You are looking for the Jumper Settings or Tuning set up?

Salsa Guy wrote:
BBCode is ON
[img] is ON
[flash] is OFF

I'm looking for the tuning set-up

KITT222 wrote:I wish I knew, but the best bet if probably to contact the guys at MonkeyWrenchRacing, as they can send you a base tune to get you started.

yea wouldn't hurt to give them an e-mail

Talk to Corey Fleming on the matrix Facebook page or corzryde on matrixowners.com

He has a supercharged dbw matrix and had to do a few things to have it run properly

I've got a tune you can try. Send me a PM with your e-mail address.