GenVibe - Community for Pontiac Vibe Enthusiasts

I'm trying to install the GM Direct bra that was recommended on my last post. ($73.15 including S & H to OKC and looks great laying in my driveway). The non-lingual directions indicate that I'm supposed to remove screws in the front wheel wells and replace them with "button" screws that the outer corners of the bra fasten to. All that is there, though, is a flat round plastic fastener.Help?

waiting for mine to arrive. hope help shows up

I think i had to remove the fastner....quite a bi#%@ to do....then replace it w/ the button snap piece. It took me a while to figure it out too!-Phil

quote:Take screws out of the wheele well area, replace them with what you got and the snaps go on there. Co sign on that but those button screws are a b--h to get in. get ready for some red thumbs/fingers

My thumbs are still sore!!! LOL

yeah mine were imprinted for a few hours

Do I just pry the fasteners out of the wheel well?

yep pretty much....i used a pair of pliars also to pull and jimmy them out.

It's on! We'll see how well I did -- 250 miles for work tomorrow and then a family vacation to Colorado on Saturday.The left front fastener come out in a heartbeat with a slotted screwdriver. The right side was a little more demanding.Thanks, everyone, for the help and support!