GenVibe - Community for Pontiac Vibe Enthusiasts

I noticed the front badge has part of the red broken off and missing. I tried to zoom in on a pic to see. Any idea how I should try fixing it?

That's a tuff one. Putting a grafxwerks decal on it wouldn't work since the piece is broken off like that...Not sure what you'd use, but if you could fab something up in the broken piece's place....you could glue it in and THEN throw a grafxwerks decal over it and never be able to tell it was broken.That's what I'd do, but again...not sure what you could use

I thought about bondo, but I figured it wouldnt come out well. Any other ideas?

in my taxidermy, I use two products, Apoxie Clay, and Apoxie Sculpt. They work like an epoxy, two parts, but they are like clay, and like plastic, and the sculpt dries like a hard acrylic like, and also has an adhering property, I use it to finish off the gaps between the skin and eye. Not sure where you can get stuff like that, but if you don't find a suitable replacement, maybe I can just send you a dab of each part.EDIT: It comes out black though, so you would still need the grafxwerx

You could chip off the rest of the red, and put down an overlay You could also just flat out replace the badge. It is held on with tape, and I think a G6 or G5 one could fit. http://cgi.ebay.com/ebaymotors...24380Or you could buy a black one http://cgi.ebay.com/ebaymotors...ories

Damn KITT, I like the black... I was going to get the overlay anyways, but buying a new one wouldnt be a bad idea.....

I am always happy to help!