GenVibe - Community for Pontiac Vibe Enthusiasts

I have one of the t-one style adapters so I can have trailer lights. However my dilema is I can't find where I'm to seperate the stock harness. There's supposed to be plugs at each of those little access pockets. Well I've opened them up and I'm not seeing anything that resembles the plugs I need near these pockets. Do I need to pull the side panels off of the hatch area to trace it back? It's a M&T package.

I'm pretty much an idiot I guess. I took another look at it. This one take the signal right at the bulb basically. The ones I've done before plugged in further back in the harness. I just have to grab my tester to see if it's all working now.I put a Curt/U-Haul receiver on it. The receiver is pretty beefy but I'm not so wild about how far below the valence it is. The photos of it on a Vibe made it look alot closer. There's probably 2 inches between the rear valence and top of the receiver. I had a hidden hitch on my P5 and it was tucked tight to the rear valence. I'll have to watch when I have my cargo rack on. It would drag on my P5 but the P5 was lower as well.