Page 1 of 1
How to remove backup lights from bumper
Posted: Wed Feb 10, 2010 9:29 pm
by A Psycho Martyr
I'm wanting to tint the light housings all around my Vibe and Taillights were a breeze, but I'm having a hard time removing the reverse lights' housing. Any help?
Re: How to remove backup lights from bumper (A Psycho Martyr)
Posted: Thu Feb 11, 2010 11:10 pm
by A Psycho Martyr
Does the bumper have to come off to get the backup lights out?
Re: How to remove backup lights from bumper (A Psycho Martyr)
Posted: Fri Feb 12, 2010 5:54 am
by PlatinumVibe08
If you turn up your giant mofo subs loud enough, the reverse lights just might vibrate out onto the ground. I'm sorry, that wasn't very helpful, but I couldn't resist.
Posted: Fri Feb 12, 2010 8:54 am
by 06pvibe
Since there is no hardware viewable from the front, I would say look from behind as if you were about the change the bulb. I'm not sure as I haven't yet done this myself, but it has to be pretty simple.
Posted: Fri Feb 12, 2010 11:39 pm
by bull77
you could always leave the bumper on...if he's still around, merzbow might have your answer.
http://forums.genvibe.com/zerothread?id=34319
Re: How to remove backup lights from bumper (A Psycho Martyr)
Posted: Sat Feb 13, 2010 5:41 am
by Merzbow
Hey I replied to your email but I was looking at the bumper and it should come right off after you pull all the screws out. I'll see if I can figure it out by looking at it and I'll let you know in a minute.
Re: How to remove backup lights from bumper (Merzbow)
Posted: Sat Feb 13, 2010 10:03 am
by A Psycho Martyr
thanks. you tha man
Re: How to remove backup lights from bumper (PlatinumVibe08)
Posted: Sat Feb 13, 2010 10:04 am
by A Psycho Martyr
hehe....true true. You a joker PlatinumVibe08
Re: How to remove backup lights from bumper
Posted: Tue Nov 03, 2015 6:48 pm
by bikes1
I'm curious about this also but I don't see the answer in this thread.