Graphxwoks overlays installed!

[ShotInTheDark]

I got my overlays in the mail today! Here's a picture of them.

Attached files

[rasermon]

Shot, looks good. Did you do all the badges?

[ShotInTheDark]

I did all the badges, in reflective blue to match the blue injen engine covers and the stripe I put on the side.I did not do the wheels or steering insert.

[Rico Rose]

I see that you put the "Pontiac" on the rear hatch of your Vibe. It looks great. On the Graphxworks web site they said that these were not tested on non-monochrome Vibes, did you have any problems getting it to stick? I hope not because after seeing your post I submitted an order for mine!!

[ShotInTheDark]

piece of cake getting it to stick. Make sure you clean it good with a q-tip and rubbing alcohol. The hardest letter to get on was the a it's a little tricky with all the curves.

[Triton]

Nice! Blue and black look pretty good together. I did the same overlays and inlay and my Vibe is Neptune. I did the Pontiac arrows (all of them including steering wheel) with reflective bright red. I like them a lot. I did blue to go with my blue Injen CAI and engine covers.