GenVibe - Community for Pontiac Vibe Enthusiasts

Should be fairly cheap and easy. I love the stock gauges in the Trix, the white/red looks awesome. But I want to personalize it a bit. Here is what I'm thinking.1) I'm moving the low fuel light a little higher up in the bezel so it can actually be seen when it comes on. It annoys me that I have to lean forward and look down to see it lit.2) I am going to get a small printout of the Matrix logo, place it over the Tach bezel just above the needle, and use an Exacto knife to cut the logo into the gauge backing. Once that is done I can put some red luminecent film behind it and wire it into the gauge lights so that when on, my little logo pops! Should be good, I would do it dead center on the speedo but the kmph is in the way. Stupid Canadians, j/k don't hurt me

Quote, originally posted by Whelan »1) It annoys me that I have to lean forward and look down to see it lit.2) if thats all it takes to annoy you, wouldn't it be easier to just stop and get gas when you get to a 1/4 of a tank?

LOL yeah I suppose, but I like to see what I can pull out of a tank.

sorry, couldn't resist. wasn't there someone else here that did something like that?

Where is the low gas light,I've never seen mine pop up yet.BTW,I'm a stupid Canadian.lol

Silly Canadians It's a little amber light located just below the "E". It comes on around a 1/8 of a tank.

heres a link to do something like that: http://www.importmodifications....html