Page 1 of 1

'06 GT Injen Intake + Magnaflow Exhaust dyno numbers

Posted: Tue Apr 25, 2006 1:54 pm
by GormalVibe
Ok folks, here is the tale of the tape. My '06 GT already had the Magnaflow installed on it when it went to the Dyno. The Baseline HP was 150.51 with Max Torque at 110.18After installation, HP was 162.93 with Max Torque at 120.23The intake was fabricated today at Injen R&D Department. They thanked me for the use of my car to build an intake to spec for all us to buy. It should be ready for purchase in about 2 weeks. Don't know the price yet.They (Injen) is also looking for a base model vibe so that they can build an intake for it.I took the car for a test drive tonight at the same place they run the Long Beach Grand Prix...... needless to say, I was impressed with the returns.

Re: '06 GT Injen Intake + Magnaflow Exhaust dyno numbers (Team Infidel)

Posted: Tue Apr 25, 2006 2:00 pm
by BlueCrush
Those are some nice gains, TI! 12+ HP & 10+ TQ. You get to keep it for being the donor car?

Posted: Tue Apr 25, 2006 2:05 pm
by GormalVibe
I paid for it, so yeah.... I get to keep it. But I paid a "reduced" rate for the intake.

Re: (Team Infidel)

Posted: Tue Apr 25, 2006 2:07 pm
by BlueCrush
Excellent! And you have the satisfaction of knowing you are the first! Bragging Rights.

Re: (BlueCrush)

Posted: Tue Apr 25, 2006 2:15 pm
by Mrizzle05
Hey buddy!!! i can be a test dummy if you want.... i have a 05 base 5-speed.I already have a cosmo CAI... but they can still test mine... i will give mine to my fiance when all is said and done.Just IM me or let me know here.

Re: (Mrizzle05)

Posted: Tue Apr 25, 2006 2:16 pm
by Mrizzle05
I also saw your car domain... your GT looks clean and nice!

Re: '06 GT Injen Intake + Magnaflow Exhaust dyno numbers (Team Infidel)

Posted: Tue Apr 25, 2006 2:23 pm
by AKLGT
Quote, originally posted by Team Infidel »The Baseline HP was 150.51 with Max Torque at 110.18After installation, HP was 162.93 with Max Torque at 120.23i'm assuming those are at the wheels too. pretty good for cai/exhaust numbers. if you factor in about 15% loss at the crank, then you're looking about 14.28 hp/11.56 tq increase. wait, can that be right on the 06 GT?

Posted: Tue Apr 25, 2006 2:32 pm
by GormalVibe
I have the dyno sheet right here. that's what I am reading off of it.

Posted: Tue Apr 25, 2006 2:36 pm
by AKLGT
ok, so then it must be at the wheels. cause i know the 06 GT is rated more than 150 hp at the crank. so the base you went off of, that is with the exhaust only? or is it completely stock?

Posted: Tue Apr 25, 2006 2:41 pm
by AKLGT
i just reread your first post. so base line, you were at 150 whp w/ the exhaust. that'll put you about 173 hp at the crank. not bad since i believe they are rated at 164 hp (you can correct me if i'm wrong about that). that would put the stock baseline somewhere around... (give or take a few obviously)... 143 whp. with the added CAI, you are looking at another 12 whp gain, so that'd put you right about (again, this is just approx) 187.4 hp. i bet if you added a unichip, you'd be close to 200 hp at the crank (174 whp)!

Posted: Wed Apr 26, 2006 1:54 am
by GormalVibe
Ok, here is a stupid question... what is a unichip?

Re: (Team Infidel)

Posted: Wed Apr 26, 2006 2:08 am
by damronjr
Quote, originally posted by Team Infidel »Ok, here is a stupid question... what is a unichip?It's a piggy-back ECU upgrade. It's also about $700.

Posted: Wed Apr 26, 2006 2:35 am
by AKLGT
someone on here found a place that sells them for under $600. that's a smoking good deal!

Re: '06 GT Injen Intake + Magnaflow Exhaust dyno numbers (Team Infidel)

Posted: Wed Apr 26, 2006 11:35 am
by LUVROK
Tell your buddies at Injen to hurry up with those 05+ GT CAIs. I want one yesterday!

Re: '06 GT Injen Intake + Magnaflow Exhaust dyno numbers (LUVROK)

Posted: Fri Apr 28, 2006 12:49 pm
by GormalVibe
Call them and ask for it. If they say they don't have one, ask to talk to R&D