Page 1 of 1
Wanted: Gauge installation guide.
Posted: Sun Jul 17, 2005 1:37 am
by McVibe
So I was going to put an oil pressure gauge, a Air/Fuel gauge and maybe a vaccum, voltage, or oil temp gauge in a pillar mount on my vibe and I was wondering if anyone had installed any of these gauges and if they could provide instructions... My no. 1 question is how do you get to the engine compartment from the interior?
Re: Wanted: Gauge installation guide. (McVibe)
Posted: Sun Jul 17, 2005 1:38 am
by Mr. Poopypants
IM freestyle, as far as I know he is the only one with A pillar gauges.
Re: Wanted: Gauge installation guide. (McVibe)
Posted: Sun Jul 17, 2005 10:13 am
by McVibe
okay I think I may have found some of the sensors, if not all of the ones I am looking for. I think this is the oil pressure sensor. Which also probably has oil temp sensor?
Attached files
Re: Wanted: Gauge installation guide. (McVibe)
Posted: Sun Jul 17, 2005 10:14 am
by McVibe
And obviosly this is the vaccum sensor... I think...
Attached files
Re: Wanted: Gauge installation guide. (McVibe)
Posted: Sun Jul 17, 2005 10:15 am
by McVibe
And please correct me if I'm wrong, but, I think this where I would hook up the Air/fuel ratio gauge.
Attached files
Re: Wanted: Gauge installation guide. (McVibe)
Posted: Sun Jul 24, 2005 2:57 am
by McVibe
Okay, thanks to Develop, I know how to install the gauges and hopefully sometime this week I'll get them put in and hopefully post an installation guide with pics