Page 1 of 1
switch for neons,
Posted: Sat Feb 26, 2005 3:42 am
by joholste
i wanted to place my switch for my neons next to the illumination controller for the interior lights and instrument panel, however i can't figure out how to get in behind it, the only way i can think of is to remove the vent cover on the driver side vent by the door, but i can't seem to get it off, does anyone know how to do this? if not i need some other good ideas for placement of the switch. This is what the switch looks like:
http://www.cardomain.com/memberpage/733209/3thanks for any help
Re: switch for neons, (joholste)
Posted: Sat Feb 26, 2005 4:07 am
by rcasciola
the way i pushed my pieces out was i opened that little compartment right there on the drivers side and then i put my hand up there and pushed those pieces out..the blank ones that is. its kinda tough but ull get it.
Re: switch for neons, (rcasciola)
Posted: Sun Feb 27, 2005 4:11 am
by satur9
me too. however the vent does just pull off if you gently pry up the corners a little.
Posted: Sun Feb 27, 2005 4:24 am
by ragingfish
Grab the little quarter holder with your finger, yank it out, then stick your fingers in to push the others out from behind.
Re: (ragingfish)
Posted: Sun Feb 27, 2005 5:00 am
by scherry2
Quote, originally posted by ragingfish »Grab the little quarter holder with your finger, yank it out, then stick your fingers in to push the others out from behind.thats how I did it. they pop right out.
Re: (scherry2)
Posted: Sun Feb 27, 2005 5:23 am
by rcasciola
yea i eventually found that way out too..lol...