Page 1 of 1
03 vibe gt questions
Posted: Wed Jan 26, 2005 2:56 am
by p1ccoloz
i just got a 03 2zz for my mr2 spyder and had a few quick questions. are the 03 vibes are cable or dbw? whats the redline on an 03? thanks!
Re: 03 vibe gt questions (p1ccoloz)
Posted: Wed Jan 26, 2005 3:01 am
by p1ccoloz
i only ask cause on the celica 03+ is dbw with an 8400 redline.
Re: 03 vibe gt questions (p1ccoloz)
Posted: Wed Jan 26, 2005 4:46 am
by theangrydwarf1
The 03's are cable driven on the throttle body. The red line is about 8200-8400 at least it is on my 03 gt.
Re: 03 vibe gt questions (theangrydwarf1)
Posted: Wed Jan 26, 2005 9:50 am
by p1ccoloz
anyone know if the knock sensor is 2 or 1 wire? any variations between the vibe's 2zz and the celicas? does the apex power fc fit your harness? heh thanks!
Re: 03 vibe gt questions (p1ccoloz)
Posted: Thu Jan 27, 2005 4:04 am
by Stang2Vibe
I seem to remember reading that GM did the engine control electronics on the Vibes so they are different in that regard from the Toyotas. I can't say for sure that this applies to the parts in question, but you'll probably run into some difficulties putting the GM version into a Toyota.
Re: 03 vibe gt questions (Stang2Vibe)
Posted: Wed Feb 02, 2005 4:46 am
by goodvibe
Our ECU harness connector is different. I think fuel cut is 8350. cable throttle. They are toyota compatible.