I replaced the clutch with LUK clutch set. Everything went well. Now, the clutch seems to engage as soon as I release the pedal (less than 1" of the floor). I'll bleed the clutch, but any adjustment in the clutch cable for this issue?
It’s a hydraulic clutch, no cable. That being said, if it’s anything like my 03 there’s an adjustment rod up under the dash between the pedal and the master cylinder
If the locknut is so tight, don't force it because you could break the plastic coupling. Detach the master clutch cylinder from the pedal and spin the plastic coupling counter-clockwise by hand then you will able to turn the locknut.
I had the free play reduced by spinning the plastic coupling (on master cylinder) counterclockwise, attach it to the clutch pedal then tighten the locknut. Clutch engagement is OK now.