GenVibe - Community for Pontiac Vibe Enthusiasts

zbyers

it's not the computer and you need a new mechanic if they're telling you that is the issue.

could be the purge valve or the vent valve. both relatively cheap parts last i looked for a first gen, and pretty easy to replace.

zbyers

what is the specific code?

zbyers

So us 11 users still using the website have been test subjects? Is THAT what the test post was all about?

zbyers

looks like it's in decent shape. What's it need? Motor?

I also thought the forklift was holding up that car body in the second picture.

zbyers

that's a sharp looking toaster!

zbyers

If you have a sunroof, there is a drain in each corner. One or more are likely plugged.

If no sunroof, check your windshield seal and for rust at the top of the windshield.

zbyers

Regarding the manual tranny...yes, the 5 speed can be problematic. No, replacing the clutch won't change it. Neither will changing the computer.

That said, generally speaking at this point if the tranny were to be a problem, it should have surfaced based on age, different drivers, etc.

zbyers

x2 what mr. claus said. Do a compression test.

zbyers

agreed with jolt...just add your own crosshatching with a sharp object.

zbyers

Yes, a 2009 Matrix XRS would be identical to your 09 Vibe GT. Basically any are legal in PA, barring that it's installed properly and doesn't cause a CEL that could give you emissions headache. I live in a county with no emissions, so they don't care here at all. cosmoracing.com might have one for t...

zbyers

Same drivetrain matrix of the same year is the same part in this case. IE: 08 Matrix FWD steering knuckle would be identical. AWD ones are different. What is strange is that RockAuto Parts shows different part numbers for the same brand part for the front hub assemblies for the '08 Matrix and the '...

zbyers

Hey all, my name is Eddie. I just acquired an 08 FWD Vibe. It was free and runs like a Japanese watch. I normally drive a Ford F250 but with $5 gallon gas here in Cali it was breaking the bank just to take my daughter to school. :o I have to say I've fallen in love with the little Vibe. Goes anywhe...

zbyers

what brand converter did you end up using? if some cheapo off brand from ebay or amazon, there's your answer.

zbyers

I wanna be the very test
Like no one ever was
To catch them is my real test
To test them is my cause

zbyers

pretty sure it mounts under the seat. seat is bolted to the floor with four 14mm bolts. lean it forward under the dash and you should see it.

zbyers

To add to the others, Walmart also does the headlight sanding for roughly $50.

zbyers

AWD Vibes are just as reliable as the rest. However, the rear subframe is known to rot out, and the rear diff is known to have issues with the bearings in the nose cone (I think that's what it's called). Outside of those issues, it's still a reliable car. We have replaced 3-4 subframes on AWD Vibes,...

zbyers

Stumbled upon a marketplace ad Sounds like you might be interested in this project Vibe. And Delavan NY is close to you also :D Wife has relatives in that small town also ... been there a few times years ago. It actually ended up selling just a few hours later..and NOT to me! If it were an hour clo...

zbyers

Stumbled upon a marketplace ad, and the seller referenced this how-to guide.

https://www.facebook.com/marketplace/it ... 282330837/

zbyers

agreed!

zbyers

How is the air filter?

It sounds like it very well could be a weak fuel pump if all else is checking out.

zbyers

Looks like the speedometer gets its signal from the ECM I know on non-ABS Vibes, the ECM gets its speed signal from the speed sensor on the tranny. Is it possible that on ABS Vibes, the ECM gets its signal from the ABS module via the individual wheel sensors? I don't think the typical OBDII code re...

zbyers

Thanks for the tip and the discussion, but, how does this affect the actual operation of the vehicle ? Great that it passes emsissions, but how does the engine computer now change settings to accomodate for the "new" data sent by the post O2 sensor... does it compensate by running too ric...

zbyers

what do you mean by getting harder?

zbyers

pro test?

zbyers

Where is your location. Generally speaking, snow tires are a better fit for most locations that see quite a bit of snow.

I live near Erie, PA and we get copious amounts of snow annually. I have never been failed by quality snow tires.

zbyers

either or. i don't think price is usually too far off from each other. so whichever has the better warranty at better cost.

zbyers

welcome aboard. show us some pictures of your ride. how long have you had the vibe?!

zbyers

I can't really imagine the inner tie rods being much different other than in length a bit. The outers are probably even interchangeable, since they all adjust. I know the outer tie rod mounts differently on the AWD than the FWD.

zbyers

SeattleJeremy wrote: ↑Mon Oct 11, 2021 11:56 am The rear struts are the only thing you need. The rear strut mount bearing doesn't move very much to start with (unlike the front) and the bump stop and dust shield (as long as they are intact) are fine to keep.

agreed.

zbyers

$3.55 for cheap stuff in Warren, PA. If I run ethanol free premium for the GT/mowers, it's something like $4.50 or so.

zbyers

burt999 wrote: ↑Mon Oct 11, 2021 11:14 am $3.15 today in N. Florida. Thank you Joe Biden.

the president does not dictate gas prices. let's leave politics in the politics section of the forum.

zbyers

Engine is in and runs, but won’t idle well. Live data on the scan tool shows both o2 sensors are dead. Thinking either a blown fuse or we forgot a ground somewhere. Either way it should be an easy fix. This one isn’t knocking or ticking at least so that’s a good start haha! does it sound fine when ...

zbyers

andrewclaus wrote: ↑Fri Oct 08, 2021 7:04 am I think the P0171 problem is causing everything else. There was mechanical damage near the intake manifold from the fan blades, and you did some work in that area. Something could be leaking. The manifold on mine is plastic. I'd check there. Use a length of heater hose to listen.

x2

zbyers

IIRC, the GT and non-GT alternators are interchangeable.

zbyers

What are the actual codes?

zbyers

$60 for all four mounts? That sounds fishy and very low quality. You'd be about $400 for OEM mounts for reference. If we presume your mechanic is using OEM mounts, $300 in labor to replace them isn't that bad. Two of the four mounts you could change yourself with ease; front and passenger side. The ...

zbyers

Glad you joined us! Post some pics of your ride.

Let us know what maintenance you need to do...Most of us will gladly convince you to keep the Vibe.

zbyers

SeattleJeremy wrote: ↑Mon Oct 04, 2021 3:38 pm
zbyers wrote: ↑Mon Oct 04, 2021 10:57 am pop the hatch glass. run whatever you need through that, shut it?
2009 and 2010 cars cannot open the rear glass.

heh. i knew that...didn't notice OP had an 09.

depending how far you're going, you are probably fine not worrying about tying it down..just tie your cargo down.

zbyers

direct swap. you can reuse the CV axles.

zbyers

pop the hatch glass. run whatever you need through that, shut it?

zbyers

check your CV axles. but if it's not that, it's quite possibly internal on the tranny....or the shifter cables.

zbyers

Pretty sure Denso is the OEM MAF, given that this is a Toyota.

Cleaning MAFs is pointless for the 2 microscopic specs of dust they may accumulate.

If you are buying MAFs from eBay/Amazon, odds are you're not buying real ones.

What says the MAF has died repeatedly? What is the CEL you are getting?

zbyers

Not having owned a vehicle with stop/start, is it something that can be turned off light lane departure correction features? There are usually modules you can buy to bypass start/stop. I don't think you have a way of actually turning it off. There are other tricks too..If it has that "sport sh...

zbyers

If your exhaust is louder than normal, there is an issue somewhere.

Would recommend taking it to a trusted mechanic if you're unable to find the issue.

zbyers

Could be any number of things without actually knowing what's going on.

Battery, alternator, seized engine, etc.

zbyers

You should probably look at it, yeah.

Without seeing or hearing anything, logically, if you hopped a curb, you probably ripped the exhaust apart somewhere.

zbyers

Not a "new" car, but I have been looking to upgrade our very rusty CRV. Took a 2016 CRV for a spin. Meh. It was a base model, and had a boatload of miles, but was a southern car so we considered it. Took a 2013ish Pathfinder for a spin..Not bad, but since we didn't HAVE to buy, we decided ...

zbyers

German torque spec!

zbyers

I also insert the bolts into their location on the new water pump. Once the old WP is out, I transfer them to that as a template. IIRC, it seems hit and miss as to whether or not you have different length bolts. The diagram joatmon linked looks like what I think I did on a water pump a couple years ...

Search found 1742 matches