GenVibe - Community for Pontiac Vibe Enthusiasts

I have a C60 from a celica modified to fit a corolla, matrix, vibe or spyder shifter
my trans works fine but has slight grinds mostly when cold but doesn't pop out just doesn't like to be rushed

you still need 1 or 2x parts from monkey wrench racing for the shifter conversion shaft and the reverse blockout if you fancy not going into reverse at 30 mph

basically the spyder shifts from the front of the shift shaft and has a 2 bolt bracket for the shifter arm to the right

the celica trans shifts from the rear and the shaft has to be knocked out and the hole in the back needs to be closed off with a freeze out plug (which i did)

the advantage is that the celica shift cable brackets bolt to the same spot as the spyder shifter arm (on the corolla vibe and matrix there is a blank undrilled boss on this spot, on my spyder swap i used a vibe trans and drilled and tapped these two holes)

aside from a spare stock shifter you could maybe cut shorter and a 6 speed trd ball knob i sold everything shift related

SLP Hood, and Voltz Badge sold

Front and Rear Bumpers, several doors, rear hatch inner panel would be lovely to be rid of as they are quite large

making a scrap run with the rest of the chassis and a lot of random large plastics any one need a piece cut out speak now or forever hold your piece

You didn't scrap it yet, did you? Also, I want those headlights, front bumper, and rear roof rack cap(p/s) if you have it.
I lost my roof rack hardware, do you have any of it by chance?

I might have a use for that c60. Mine sounds like it's about to go, I don't think it will like 300hp much. I'm hoping I can make it last until the e154f goes in,
but that is unlikely.

I did scrap chassis, front subframe, hubs, p/s rack
saved rear beam, sway bars, heater box, pretty much everything that unbolted

I do have the foggy headlights, decent front bumper, the grumpy grindy c60, and all roof rack hardware besides crossbars

the grindtastic c60 miraculously sold to a guy swapping a 2zz into an aw11 Mr2 pretty noble cause for it

my fan was not blowing at low, so for the last 2 years was running at medium. this morning, no fan except for high.

do you have a blower resistor?

o4 pontiac vibe

thanx in advance

i should let me confirm, ship or pickup?

ship! 'm in the chicagoland area

edit 2 december: i didn't realize the resistor was so inexpensive. i ended up picking one up at the local parts store here. all set

bump for pending bumper sale

still have several doors mirrors switches small bits, rear beam, lower control arms full poly bushings set

Any chance you have a windshield fluid pump (shipped to Michigan)? TIA

Do you have passenger side cladding for 2003 Vibe? If do, how much?

i have a lot of cladding unpainted, blue or black and the whole side or one door?

It will be the whole passenger side in black; how much and shipping charges to Rochester, NY 14622. Thanks

Don't need the doors.

OK I sorted through my trim, I do have a complete p/s in black
I have pending sale on d/s blue and p/s black front door cladding

I have an additional p/s front door cladding in black
Also black:
2x p/s rear door
1x p/s rear qtr
2x d/s rear qtr (1x in unpainted grey)
1x d/s front fender (scuffed w/ one broken clip)
1xp/s front fender
And also 1x d/s+p/s front fender cladding in unpainted grey

https://docs.google.com/file/d/0B_sios5 ... cslist_api" onclick="window.open(this.href);return false;
https://docs.google.com/file/d/0B_sios5 ... cslist_api" onclick="window.open(this.href);return false;
https://docs.google.com/file/d/0B_sios5 ... cslist_api" onclick="window.open(this.href);return false;
https://docs.google.com/file/d/0B_sios5 ... cslist_api" onclick="window.open(this.href);return false;

Also have several interior plastic pillar trims as well as the rear cargo floor and seat backs

Thank you for your quick response, but these pieces I have; I need the bottom section where the rocker is, all across the bottom. about that, not making myself clear. I hope you have that. Thank you again.

i have a few side skirts left but gonna have to pull them down not sure if i have a black one still

msu90 wrote:Any chance you have a windshield fluid pump (shipped to Michigan)? TIA

didnt see your post i should I will let you know

Bad Vibe wrote:I did scrap chassis, front subframe, hubs, p/s rack
saved rear beam, sway bars, heater box, pretty much everything that unbolted

I do have the foggy headlights, decent front bumper, the grumpy grindy c60, and all roof rack hardware besides crossbars

Sorry it took so long for me to reply... I didn't have it set to send me email updates.

I could use the roof rack bolts soon. And also the rear caps. Get me a price shipped to 89052 if you still have em.

Long shot in the dark. I read previous posts that you have a upper and lower spoiler for sale? Can you send me pics?

Mid spoiler sold, upper spoiler is black and still wrapped up but I'll go check it out of you're interested

Yes interested. Can you send some pictures?

Do you still have the battery hold down clamp by chance? How much would you like for it?

I should still have it, i'll take a look while I'm playing paparazzi with my disrobed spoiler tonight

OK, I found out I need a new rear wiper motor as well. Do you have that? Thanks!

That I definitely have, sorry for making everyone wait on pics my parts are in detached garage beyond a muddy field of melting snow and a not hard to get to and school work gym keeps getting in way off Thurs will get back to everyone then

Rear spoiler black is good,

Rear wiper motor with or without arm is good

P/s mirror is no good only have drivers side painted blue left

Also have rear glass w/tint and black painted top part w/ washer sprayer

Also took pics of

Pair of

Foggy headlights
Front calipers
2 Good p/s tail lights ( and one d/s with a Spyder crack)

Also washer bottle


Dash bezel
05+ upper grills

Fogs sold, here's pics - also while im sure i have a battery tie down i have no idea where it may be and could not find it after 1/2 hr of digging so....





























ghetto looking but functional radio






abs unit

Is the metal part of the hatch glass plain black or metallic black?

Painted Black metalic

How much do you want for the rear wiper motor? (I don't need the arm.) If you find the battery clamp, great; if not, not a problem.

pm'd

Fogs sold, Wiper motor and spoiler ready to be shipped if you guys are still interested

Did you say you had side skirts? I have a 2004 Vibe base and wanted to see if I could put those on. The part number may be part of the
12498773 Sport Package

no sport package parts besides spoiler just basic grey side skirts

Thanks, sent a pm.

Do you still have that black rear spoiler and does it fit a 2003 vibe? I'm interested if it does and thanks for checking on the skirts, I have all those that you have, I need the bottom one, one whole piece that runs at the bottom passenger side.

Still have spoiler and basic 03 side skirts unpainted

Do you still have the radio bezel w/ switches? How Much?
I live in Oregon.

Would you have a driver side
rear tail light assembly that fits 2005 base vibe? How much?
rickiannitelli@hotmail.com

I have the one pictured above with the crack in it, still usable Ps I have a good one

When you say basic side skirt are you referring to the lower one? Can you post a picture, I'm interested in the spoiler and the skirt, how much and shipping charges for 14622 zip.

any one buying this spoiler?

TRD Shiftknob? How much shipped to 74019

is the leather console box still around?

pretty sure i sold it ill double check tho

Did you sell the driver's side rear tail light/blinker assembly? You mentioned that you have a cracked one (picture shown) but also maybe a good one? Can you send me a private message if you still have them with costs to ship to 97202? Thanks.

What did you want for the spoiler and headlight assemblies?

Would you happen to have the antenna mast and base?

is there a cooling fan motor available for 2006 base? cost?