I have been looking over the forum for good posts on installing a backup camera in their Vibe and wiring it to the reverse gear wire so it automatically shows the camera when you shift into reverse. So far everyone is doing it differently and in multiple locations. I have a 2007 Vibe and I just installed a Pioneer AppRadio 3 in it and everything works great. I have a backup camera camera but before I start to install I was hoping I could get some advice on the easiest place to get a 12v power supply (preferably in the rear of car) and where to tape into the reverse gear wire (again preferably in the rear of the car). The video cable I know obviously goes to the video in port on the back of the radio as I have the wire connected already but just coiled and secured for now until I get the rest of the wiring complete. Instructions, pictures, diagrams are all welcomed for this project.
Thanks,
TheGoat