I have a 2009 base model, bone stock with the 2.4 liter engine and manual transmission. I just hooked up an OBD2 sensor, and in the "tests results" section of Torque one of my 02 sensors (bank 1 sensor 2) says "test incomplete or a dependent test failed". I don't have any failed tests and its been at least 1000 miles of highway and city driving since I unplugged the battery or reset the ECU. I did reset the ECU today and drove about 100 miles to see if the tests would complete, but I ended up with the same results. My gas mileage (according to torque) seems a bit low as well... it was averaging 26 MPH with cruse control set at 85 on the interstate, and about 27-28 with the cruise control set at 70.
Does anyone who has a 2.4 and the Torque app have the same result? Not sure if this is normal or if I need a new 02 sensor.