Hello all, I'm wanting to fix the front door rocker molding. The clips have busted off and I'm not sure of the correct ones. Also how would I remove the molding without busting these off? Suggestions? 2003 Vibe GT I've seen this but I'm not sure the trim is the same because mine doesn't have any cli...
I did replace the negative terminal but not the positive yet, I was planning on doing that after getting the car started again. But I can try replacing that one too if other gussestions don’t come up first.
Thank you
Hello everyone, I need help diagnosing my electrical issue. 2003 GT My starter went out luckily when I was at home. I ordered a new one, installed it, then the issue started. Once I connect my battery to the car. All headlights, horn, emergency flashers, dome light all work. But as soon as I turn th...
Hello everyone, I need the brake backing plates for 2003 Vibe GT rear left and right. I had the same issue as "Mozilla2ZZ" had in this post. http://forums.genvibe.com/phpBB3/viewtopic.php?f=26&t=46608&p=522390&hilit=brake+rear+backing+plate+03#p522390 My hub was rust welded to ...
Hello all, I'm looking for suggestions on how to install a neutral switch in to the vibe. I've installed a remote starter into my 2003 Vibe GT and everything works fine, but my heart always stops when I go to press the remote start button sense it's a manual transmission and I'm still trying to brak...
I have a 2003 vibe GT and the previous owner must have been a woman, the bezel around the radio has scratches as if she couldn't ever find the right station.. So parts of my bezel are back to plastic black.. I would like to paint it back to the stock color and also the driver side window controls.( ...
I was driving and then got home and opened the packages and then let the vibe run on ramps for 15 min and then put a block of wood on the gas petal to about 2700rpms.. for a couple min and then i was just watching the temps increase... maybe if someone reading this could do a test on a good cat and ...
well the temps are in...... pre cat is 520f and after cat is 320f ..... so from what i'm told... my cat is clogged... still use-able till its fully clogged ... but i'm definitely in the looks for a new cat
i just got both my o2 sensors in the mail.. also my infrared thermometer in the mail today...so at the moment the vibe is warming up to temp so i can test the catalytic converter to see if theres pressure building up... i did notice that the o2 sensors are located under the car and not just one like...
I do not believe there is an exhaust leak...the vibe sounds quiet as always.. i did take a look on http://www.hottexhaust.com/" onclick="window.open(this.href);return false; and for the bolt in oem for my vibe is $529.52 with a $90.02 savings if i check the save now box and then a $109.88 ...
I would like to get a new catalytic converter... but I would like to make sure its bad before I do get a new Catalytic converter... so this is what I'v got going on... I ordered a IF laser so I can determine the temperature of the cat before and after... also I ordered new O2 sensors... I did save $...
I went back to autozone and it was a p0420 code. But before I got back to autzone my check engine light turned back off.. I'm confused because autozone is saying to use this Catalyst Cleaner $25.. that should fix it unless its broken... but if i'm going to spend $25+tax and it doesn't work.. i would...
THANK YOU IN ADVANCE!! My check engine light has been on and off ever sense Iv bought the vibe back in December... a few months ago, i did a lot of suspension work on the front end. i also replaced the fuel cap with a $5 cap. and once i was all done with the repairs. I returned the battery to the vi...
I figured out my shaking !!! It was .................... the lug nuts!!!! I bought 4 new wheels(rims) and they came with new lug nuts that "are made for your car" and when I had my tires put on they switched out my lug nuts... and its been shaking ever sense.... well after the beads not fi...
I would say that the beads helped but didn't cure the shaking... I'm happier with them.. but i would be 100% happy if that would have fixed the shaking.... maybe if i change out the rear bearings and hub struts .... i thinks that's what i'm going to do.... and then head back in for a neither alignme...
I just had new tires and rims put on my vibe. The rims can't use the metal weights so they use the sticky weights. After they balanced them. I took the car for an alignment. The car now has a shake at 65-80 but will shake from 80-50. I had the tire place re balance my tires. it helped a little. But ...
image.jpg I'm pretty sure from what iv found that this is a 33mm but I have to wait for the auto store to open to try to get one. I got one from autozone $15 for it though :0 image.jpg Tie rod has a codder pin in the end of it... Who ever put this tie rod on, snipped the pin down to the end on it.....
This Vibe will stay as my daily driver till I at least get 400,000. :D I'm in the prosess of getting the girlfriend to save up for a automatic vibe :)) To bad the gt's only come in 6 speed sticks. But then again it's good for me, I love my 6speed :) I picked up the tie rods today and I'm going to tr...
Thanks to all for the comments! I did order strut mounts, I missed it on my list so I have edited that and add it on, $51 each :0 I have received the full check from progressive for a total of $4640.97 :) so a little extra then I was told :D Also I have got a quote for the painting and door repairs....
They are mailing me a check for $4600 and I keep the car... I know it's going to be a lot of work, but it only has 117xxx miles and gets me 34-38 mpg.. I can't just give that up. Plus it should ride like a dream with this new suspension :) Well the car is at the body shop till this weekend. Them I'l...
Last week I hit a deer very lightly on the driver side.. Rather then hitting him right on I swerved to the right and went down in to a Wide ditch.. the vibe took it like a champ and drove down and back up. Once I was back on the road, I came to a complete stop and looked at the damage. The car was s...
I set out to fix the this problem on my 2003 vibe gt. It's been like this ever sense I bought the car 7 months now. It was really tricky to get it out but once that top bolt came out, it was all up hill from there. I opened it up and turned the big white gear 180° and put it back in. Tested it out ...
30 Minute Care Wash :D Very clean for living in the country In the morning I'm changing breaks. 4 New drilled and slotted rotors ($125) :D their black :D 20 new lug nuts ($17.00) :D 8 New blue break pads.($25.00) Pretty excited to get this done. rsz_1image[1].jpg rsz_3image.jpg Last weekend I did a ...
DERF~!!!~ THANK YOU SO MUCH! You've been a huge inspiration for my projects for the vibe!! Once i got my vibe, i started to see what people have done. And I found you on youtube and I'd done a lot of what you have shown. Your videos are very to the point and helpful! Thank you again DERF!! (Fred) ;)
Hey Guys ~!~ I'm starting this Topic as a point of interest and also brain storming.. So Please help me in my quest... I'm wanting to add a fuse box located under the dash or under the hood. ( placement inst to important at this point) The purpose for the fuse box would to house the additional light...
I just did a coolant drain on the 2003 vibe GT this weekend. pulled almost all the coolant out of the system. and then refilled with Peak 50/50 Pre-Diluted... It took One Gallon at the time.. and then a 1/4 after the first drive.. now its all topped off :D From what iv been reading the dex-cool eats...
Very nice Vibe!! I wouldn't paint the rims. Personal opinion.. I'm also a new Vibe owner :D Check out my forum I posted for alpine :D http://forums.genvibe.com/phpBB3/viewtopic.php?f=18&t=43227" onclick="window.open(this.href);return false; I love my bass!! And Alpine has always had me...
I upgraded to LEDs also! My inside is so bright!! My map light has a 18led panel :) After doing my inside, I wanted the outside.. So I ordered the reverse lights first.. And yeah their brighter then the stock so then I ordered the Amber turn singls... This is where I went to far... I ordered 4 and I...
I think i'm going to go with both idea's :D debadge the hatch but put a overlay on the arrow :D and door emblems I think ill keep but replace the GT on the left door... So what do you think would be the best product to get the badges off? as you can see from the picture of my hatch. the G has fell o...
Hey Guys! So my G on the GT fell off the back of the car.. By some luck I found it today in my yard. Weird how it didn't fall off down the road. But My question is, What is your suggestions to do? Replace them with new ones from GM? just debadge them? just debadge the GT? Paint the old ones? What do...
Hey Guys. I'm wanting to give a little information on what the previous owner of my vibe didn't think of. The fuel door for my 2003 Vibe GT would pop open okay but wouldn't want to open all the way. It even got to the point that it dented its self. The VERY SIMPLE fix for this fuel door was just a q...
Hey guys, I'm a recently New 2003 Vibe GT Owner. :D Happy as can be!!! I'v already done some projects to it :D This project was all Audio. There's plenty of Topics for audio and changing radios.. So I won't go in to much details about my Stereo.. I changed the whole audio of the car. JVC Bluetooth/U...
This happened to a neither car of mine.. check all the vacuum hoses under the hood. Mine was a VERY small guy about 1" inch that looked on but wasn't. So double check it all... If this doesn't work then i would also try to disconnect the batter for about 20 minutes.